Putting the discovery vehicle into this mode will make sure that the workshop ride heights are controlled more accurately.
15 16 Align the steering to straight ahead.
Make sure the vehicles fuel tank is full, if not distribute extra weight evenly over discovery the fuel tank area to represent a full tank of fuel.Damaged or leaking air suspension components.Depending on the amount workshop of fuel in the tank, calculate the amount of weight which must workshop be added: 1 litre of fuel weighs.8 kg (1.7 pounds) 1 Imperial gallon of fuel weighs.6 kg (8.0 pounds) 1 US gallon of fuel weighs.0.Type: Front Independent with workshop single rate coil spring, twin tube damper and high stress anti-roll bar.Principle of Operation, for a detailed description of the Suspension System and operation, refer to the relevant Description and Operation section of the workshop manual.Set the gap, between the underside of the toe link rubber boot and the integrated body frame bracket, to 10 mm (0.473 in).Failure to follow this instruction will result in damage to the toe link or integrated body frame.Refer to: Front Suspension (204-01 Front Suspension, Description and Operation Rear manual Suspension (204-02 discovery Rear Suspension, Description and Operation).Check the tie rod ends, suspension joints, wheel bearings and wheels and tires for damage, wear and free play.Electronic Engine Controls, automatic Transmission ZF 6HP26, automatic Transmission ZF 6HP28.Make sure the steering is in the straight ahead position.Adjust the front toe.Repeat the castor measurement.Caution : Diagnosis by substitution from a donor vehicle is NOT acceptable. Stage three: Tighten the rising track rod end locking nut.
Substitution of rising control modules does not guarantee confirmation of a fault and may also cause additional faults in the hack vehicle being checked and/or the donor vehicle.
Caution : Make sure the toe link anti-rotation tang is fully seated in the integrated body frame before tightening the toe link retaining nut.
Power Brake Actuation, anti-Lock Control, power Steering, tDV6.7L Diesel repair manual.
Make sure that only the manufacturers' recommended four wheel alignment switchback equipment is used.
Front bottoming or riding low Damaged suspension components Air spring fault Check the suspension components for andreas damage.
Rotate the front camber adjusting bolt until the correct value is obtained.Rotate the track rods to adjust each individual front toe to the correct value.Position the vehicle on a calibrated, level, vehicle lift.Check the front and rear suspension for signs of damage or wear.Stage four: Rotate the steering wheel until both front toe measurements are equal.Follow the on-screen instructions until the normal mode process has finished.Adjust the rear bump steer.Brake System, parking Brake and Actuation, hydraulic Brake Actuation.The fuel tank capacity.3 litres (18.9 Imperial gallons) (22.7 US gallons).Make sure the air suspension is set andreas to normal ride height.Tighten the lower arm xkcd rear castor polaris adjusting bolt.